Subaru Outback (BR): Manual climate control system (if equipped)
READ NEXT:
1) Fan speed control dial 2) Temperature control dial 3) Airflow control buttons 4) Air conditioner button 5) Air inlet selection button 6) Rear window defogger button (Refer to “Defog
The fan operates only when the ignition switch is turned to the “ON” position.
The fan speed control dial is used to select four fan speeds.
This dial regulates the temperature of airflow from the air outlets over a range
from the blue side (cool) to red side (warm).
SEE MORE:
A: PROCEDURE
CAUTION: Remove foreign matter (dust, water, oil etc.) from the VDCCM&H/U connector during removal and installation.
NOTE:
To check the harness for open or short circuits, shake problem spot or connector.
Refer to "Check List for Interview". <Ref. to VD
The hazard warning flasher is used to warn other drivers when you have to park
your vehicle under emergency conditions. The hazard warning flasher works with the
ignition switch in any position.
To turn on the hazard warning flasher, press the hazard warning button on the
instrument panel.
© 2010-2026 Copyright www.suoutback.com
