Subaru Outback (BR): Manual climate Control panel

1) Fan speed control dial 2) Temperature control dial 3) Airflow control buttons 4) Air conditioner button 5) Air inlet selection button 6) Rear window defogger button (Refer to “Defogger and deicer” F3-34.)
READ NEXT:
The fan operates only when the ignition switch is turned to the “ON” position.
The fan speed control dial is used to select four fan speeds.
This dial regulates the temperature of airflow from the air outlets over a range
from the blue side (cool) to red side (warm).
Each airflow control button activates the following air outlets.
: Instrument panel outlets
: Instrument panel outlets and foot
outlets
: Foot outlets, both side outlets of
the instrument p
SEE MORE:
If the moonroof cannot be closed with the moonroof switch, you can close the
moonroof manually.
1. Take out the screwdriver from the tool bucket.
2. Open the overhead console. Refer to “Overhead console” F6-8.
3. Remove the two screws that retain the moonroof switch body. Then, remove the
A: REMOVAL
1) Disconnect the ground cable from battery.
2) Remove the rear gate trim. <Ref. to EI-160, REMOVAL, Rear Gate Trim.>
3) Remove the rear gate latch & actuator assembly.
Remove the bolts and pull out the rear gate latch & actuator assembly to
the vehicle front.
Disconn
© 2010-2026 Copyright www.suoutback.com
