Subaru Outback (BR): Tether anchorage location
Subaru Outback (BR) 2010-2015 Owners Manual / Seat, seatbelt and SRS airbags / Child restraint systems / Top tether anchorages / Tether anchorage location
Outback
Three tether anchorages, i.e., ones for the right, center and left positions, are already installed on the rear edge of the roof. Open the cover flap to use each anchorage.
READ NEXT:
To hook the top tether
CAUTION
Always remove the head restraint when mounting a child restraint system with
a top tether. Failure to do so may prevent the top tether from being fastened tightly.
Outback
1. Remove the
*SRS airbag (Supplemental Restraint System airbag)
*SRS: This stands for supplemental restraint system. This name is used because
the airbag system supplements the vehicle’s seatbelts.
Your vehicle is equipped with a crash sensing and diagnostic
Models with SRS airbags and lap/shoulder restraints for driver, front passenger,
and window-side rear passengers
Your vehicle is equipped with a supplemental restraint system in addition to
a lap/shoulder belt at each front seating position and each rear window-side seating
position. The supplemental restrai
SEE MORE:
Installing child restraint systems with A/ELR seatbelt
WARNING
● Child restraint systems and seatbelts can become hot in a vehicle that has
been closed up in sunny weather; they could burn a small child. Check the child
restraint system before you place a child in it.
● Do not leave an unsecured child restraint system in your vehicle.
Knock Sensor
A: REMOVAL
1) Disconnect the ground cable from battery.
2) Remove the cover (A) and clip (B) from air intake
boot assembly.
3) Loosen the clamp (A) which connects the air intake
boot assembly and air cleaner case.
4) Loosen the clamp (B) which connects the air intake
boot assembly and throttle bo
© 2010-2026 Copyright www.suoutback.com
