Subaru Outback (BR): Sounding a panic alarm
Subaru Outback (BR) 2010-2015 Owners Manual / Keys and doors / Remote keyless entry system / Sounding a panic alarm
To activate the alarm, press the “PANIC” button once.
The horn will sound and the turn signal lights will flash.
To deactivate the panic alarm, press any button on the remote transmitter. If a button on the remote transmitter is not pressed, the alarm will be deactivated after approximately 30 seconds.
READ NEXT:
Selecting audible signal operation
Using an electronic chirp, the system will give you an audible signal when the
doors lock and unlock. If desired, you may turn the audible signal off.
To deactivate the audible signal, perform the
Replacing the battery
CAUTION
● Do not let dust, oil or water get on or in the transmitter when replacing the
battery.
● Be careful not to damage the printed circuit board in the transmitter when replacing
Replacing lost transmitters
If you lose a transmitter or want to purchase additional transmitters (up to
four can be programmed), you should reprogram all of your transmitters for security
reasons. It is recommended that you
SEE MORE:
Timing Belt Cover
A: REMOVAL
NOTE:
When replacing a single part, perform the work with
the engine assembly installed to body.
1) Remove the crank pulley. <Ref. to ME(H4SO)-
45, REMOVAL, Crank Pulley.>
2) Remove the stopper rod.
3) Remove the timing belt cover LH (A).
4) Remove the front timing belt cover (B)
Entering the vehicle while it is running via remote start
1. Unlock the vehicle doors using the remote keyless entry system. If the vehicle’s
doors are unlocked manually using the key, the vehicle’s alarm system will trigger
(if the alarm system is armed prior to activating the remote engine start system)
and the engine will turn off. Inserting t
© 2010-2026 Copyright www.suoutback.com
