Subaru Outback (BR): Selecting audible signal operation
Using an electronic chirp, the system will give you an audible signal when the doors lock and unlock. If desired, you may turn the audible signal off.
To deactivate the audible signal, perform the following procedure. You can also use the same steps to restore the function.
1. Sit in the driver’s seat and shut all doors and the rear gate.
2. Press the unlock side of the power door locking switch.
3. Insert the key into the ignition switch.
4. While holding down the unlock side of the power door locking switch, pull the key out and re-insert it into the ignition switch at least 5 times within 10 seconds after performing step 2.
5. Open and close the driver’s door within 10 seconds after performing step 4.
6. To indicate completion of the setting, the turn signal lights flash 3 times and the chirp sounds 3 times.
You may have the above procedure performed by your SUBARU dealer.
READ NEXT:
Replacing the battery
CAUTION
● Do not let dust, oil or water get on or in the transmitter when replacing the
battery.
● Be careful not to damage the printed circuit board in the transmitter when replacing
Replacing lost transmitters
If you lose a transmitter or want to purchase additional transmitters (up to
four can be programmed), you should reprogram all of your transmitters for security
reasons. It is recommended that you
Programming the transmitters
The remote keyless entry system is equipped with a special code learning feature
that allows you to program new transmitter codes into the system or to delete old
ones. The system can learn up to
SEE MORE:
Flywheel
A: REMOVAL
1) Remove the transmission assembly. <Ref. to
6MT-25, REMOVAL, Manual Transmission Assembly.>
2) Remove the clutch cover and clutch disc. <Ref.
to CL-11, REMOVAL, Clutch Disc and Cover.>
3) Using the ST, remove the flywheel.
ST 498497100 CRANKSHAFT STOPPER
Flywheel
B: I
Operation during cold weather
Carry some emergency equipment, such as a window scraper, a bag of sand, flares,
a small shovel and jumper cables. Check the battery and cables. Cold temperatures
reduce battery capacity. The battery must be in good condition to provide enough
power for cold winter starts.
Use an engine oil
