Subaru Outback (BR): LOCK
The key can only be inserted or removed in this position. The ignition switch will lock the steering wheel when you remove the key.
If turning the key is difficult, turn the steering wheel slightly to the right and left as you turn the key.
The key can be turned from “Acc” to “LOCK” only when the key is pushed in while turning it (all models) and the select lever is in the “P” position (AT and CVT models).
READ NEXT:
Acc
In this position the electrical accessories (radio, accessory power outlet, etc.)
can be used.
ON
This is the normal operating position after the engine is started.
START
CAUTION
Do not turn the ignition switch to the “START” position while the engine is running.
The engine is started in this position. The starter cranks the engine to start
it. When the key is
SEE MORE:
Power steering
CAUTION
Do not hold the steering wheel at the fully locked position left or right for
more than 5 seconds. This may damage the power steering pump.
The power steering system operates only when the engine is running.
If you lose power steering assist because the engine stops or the system fails
General Description of Drive Shaft System
A: SPECIFICATION
1. PROPELLER SHAFT
2. FRONT DRIVE SHAFT ASSEMBLY
Axle diameter
Axle length
3. REAR DRIVE SHAFT ASSEMBLY
Axle diameter
Axle length
B: COMPONENT
1. PROPELLER SHAFT
Propeller shaft
Rear differential (VA1-type)
Rear differe
© 2010-2026 Copyright www.suoutback.com
