Subaru Outback manuals

Subaru Outback (BR): Canceling the function for meter/gauge needle movement upon turning on the ignition switch

Subaru Outback (BR) 2010-2015 Owners Manual / Instruments and controls / Meters and gauges / Canceling the function for meter/gauge needle movement upon turning on the ignition switch

It is possible to activate or deactivate the movement of the meter needles and


It is possible to activate or deactivate the movement of the meter needles and gauge needles that takes place when the ignition switch is turned to the “ON” position.

1. Turn the ignition switch to the “LOCK” or “Acc” position.

2. Press the trip knob to show “ ” or “ ” on the trip meter display

The display can be switched as shown in the following illustration by pressing the trip knob.

3. To change the current setting, press the trip knob for at least 2 seconds.


3. To change the current setting, press the trip knob for at least 2 seconds.

: Deactivated: Activated
NOTE: Deactivated


NOTE

● Your vehicle’s initial movement setting of the meter/gauge needles has been set for activation “ ” at the time of shipment from the factory.

● It is not possible to change the initial movement setting of the meter/gauge needles when the ignition switch is in the “ON” position. Change the setting when the ignition switch is in the “LOCK” or “Acc” position.

READ NEXT:

 Speedometer

The speedometer shows the vehicle speed.

 Odometer

This meter displays the odometer when the ignition switch is in the “ON” position. The odometer shows the total distance that the vehicle has been driven. If you press the trip knob when the

 Double trip meter

1) Trip knob This meter displays the two trip meters when the ignition switch is in the “ON” position. The trip meter shows the distance that the vehicle has been driven since you last set

SEE MORE:

 Other sound setting controls (type A audio)

Each brief press of the “MENU” button changes the control modes in the following sequence. Choose the desired settings for each mode by turning the “TUNE/TRACK/CH” dial. The control function returns to the tune/ track/channel control mode after approximately 5 seconds. SVC setting

 Heater Core

A: REMOVAL 1) Disconnect the ground cable from battery. 2) Using the refrigerant recovery system, discharge refrigerant. <Ref. to AC-24, PROCEDURE, Refrigerant Recovery Procedure.> 3) Drain the coolant from the radiator. H4 non-turbo model: <Ref. to CO(H4SO)-14, DRAINING OF ENGINE COOL

© 2010-2026 Copyright www.suoutback.com