Subaru Outback (BR): ECO gauge
1) U.S.-spec. models
2) Except U.S.-spec. models
The ECO gauge shows the difference between the average rate of fuel consumption and the current rate of fuel consumption. Using the average rate of fuel consumption since the trip meter was last reset, the indicator needle behaves as described in the following items.
U.S.-spec. models:
If the current rate of fuel consumption is lower than the average rate of fuel consumption, the indicator needle points to the “+” side. If the current rate of fuel consumption is higher than the average rate of fuel consumption, the indicator needle points to the “−” side. When the indicator needle is pointing to the “+” side, it indicates fuel-efficient driving.
Except U.S.-spec. models:
If the current rate of fuel consumption is lower than the average rate of fuel consumption, the indicator needle points to the “−” side. If the current rate of fuel consumption is higher than the average rate of fuel consumption, the indicator needle points to the “+” side. When the indicator needle is pointing to the “−” side, it indicates fuel-efficient driving.
NOTE
● The ECO gauge shows only an approximate indication.
● After resetting the trip meter, the average rate of fuel consumption is not shown until driving 0.6 mile (1 km). Until that time, the ECO gauge does not operate.
READ NEXT:
Warning and indicator lights
Several of the warning and indicator lights illuminate momentarily and then go
out when the ignition switch is initially turned to the “ON” position. This permits
checking the operation of the
SEE MORE:
Adjusting the front seat shoulder belt anchor height
The shoulder belt anchor height should be adjusted to the position best suited
for the driver/front passenger. Always adjust the anchor height so that the shoulder
belt passes over the middle of the shoulder without touching the neck.
To raise:
Slide the anchor up.
To lower:
Push the relea
Synthetic leather upholstery
The synthetic leather material used on the SUBARU may be cleaned using mild soap
or detergent and water, after first vacuuming or brushing away loose dirt. Allow
the soap to soak in for a few minutes and wipe off with a clean, damp cloth. Commercial
foam-type cleaners suitable for synthetic le
