Subaru Outback (BR): Synthetic leather upholstery
The synthetic leather material used on the SUBARU may be cleaned using mild soap
or detergent and water, after first vacuuming or brushing away loose dirt. Allow
the soap to soak in for a few minutes and wipe off with a clean, damp cloth. Commercial
foam-type cleaners suitable for synthetic leather materials may be used when necessary.
NOTE
Strong cleaning agents such as solvents, paint thinners, window cleaner or gasoline
must never be used on leather or synthetic interior materials.
READ NEXT:
Use a soft, damp cloth to clean the climate control panel, audio equipment, instrument
panel, center console, combination meter panel, and switches.
NOTE
Do not use organic solvents such as paint
To clean the navigation monitor, wipe it with a silicone cloth or with a soft
cloth. If the navigation monitor is extremely dirty, clean it with a soft cloth
moistened with neutral detergent then
SEE MORE:
This light blinks approximately 60 seconds after the ignition switch is turned from “ON” position to the “Acc” or “LOCK” position or immediately after the key is pulled out. Refer to “Immobilizer” F2-3. If the indicator light does not flash, it may
A: PROCEDURE
CAUTION:
Subaru Select Monitor is required for reading DTC, performing diagnosis and reading current data.
Remove foreign matter (dust, water, oil, etc.) from the body integrated unit connector during removal and installation.
Registration of the immobilizer is ne
© 2010-2026 Copyright www.suoutback.com
