Subaru Outback (BR): Navigation monitor (if equipped)
Subaru Outback (BR) 2010-2015 Owners Manual / Appearance care / Cleaning the interior / Navigation monitor (if equipped)
To clean the navigation monitor, wipe it with a silicone cloth or with a soft cloth. If the navigation monitor is extremely dirty, clean it with a soft cloth moistened with neutral detergent then carefully wipe off any remaining detergent.
NOTE
● Do not spray neutral detergent directly onto the monitor. Doing so could damage the monitor’s components.
● Do not wipe the monitor with a hard cloth. Doing so could scratch the monitor.
● Do not use cleaning fluid that contains thinner, gasoline, or any other volatile substance. Such cleaning fluid could erase the lettering on the switches at the bottom of the monitor.
READ NEXT:
Maintenance schedule
The scheduled maintenance items required to be serviced at regular intervals
are shown in the “Warranty and Maintenance Booklet”.
For details about your maintenance schedule, read the separate
Maintenance precautions
When maintenance and service are required, it is recommended that all work be
done by an authorized SUBARU dealer.
If you perform maintenance and service by yourself, you should familiarize yoursel
SEE MORE:
Inhibitor Switch
A: INSPECTION
When the driving condition or starter motor operation is improper, first
check the shift linkage for improper operation.
If the shift linkage is functioning properly, check the inhibitor switch.
1) Remove the air intake boot assembly. <Ref. to IN(H4SO)-8, REMOVAL, Air Intake
Boo
Rear Inner Remote
A: REMOVAL
1) Remove the door trim. <Ref. to EI-60, REMOVAL, Door Trim.>
2) Remove the screws and detach the rear inner remote handle.
B: INSTALLATION
1) Before installation, check the following items.
Cable is free from deformation such as fray.
Grease is applied sufficiently to cable jo
© 2010-2026 Copyright www.suoutback.com
