Subaru Outback manuals

Subaru Outback (BR): Auto-dimming mirror with compass and HomeLink® (if equipped)

Subaru Outback (BR) 2010-2015 Owners Manual / Instruments and controls / Mirrors / Auto-dimming mirror with compass and HomeLink® (if equipped)

1) HomeLink® button 1


1) HomeLink® button 1 2) HomeLink® button 2
3) LED
4) HomeLink® button 3
5) Sensor
6) Automatic dimming on/off button 7) Compass display button 8) Compass display

The auto-dimming mirror has an anti-glare feature which automatically reduces glare coming from headlights of vehicles behind you. It also contains a built-in compass and HomeLink® wireless control system.

● By pressing the automatic dimming on/ off button, the automatic dimming function is toggled on or off. When the automatic dimming function is on, the LED indicator will illuminate.

Even with the mirror in the automatic dimming mode, the mirror surface turns bright if the transmission is shifted into reverse. This is to ensure good rearward visibility during reversing.

● By pressing the compass display button, the compass display is toggled on or off. When the compass is on, an illuminated compass reading will appear in the upper right corner of the mirror.

When cleaning the mirror, use a paper towel or similar material dampened with glass cleaner. Do not spray glass cleaner directly on the mirror as that may cause the liquid cleaner to enter the mirror housing and damage the mirror.

READ NEXT:

 Photosensors

The mirror has a photosensor attached on both the front and back sides. During nighttime driving, these sensors detect distracting glare from vehicle headlights behind you and automatically dim

 Compass zone adjustment

Compass calibration zones 1. Refer to the “Compass calibration zones” map shown above to verify that the compass zone setting is correct for your geographical location. 2. Press and hold the

SEE MORE:

 Antenna

A: REMOVAL 1. RADIO ANTENNA AMPLIFIER Sedan model 1) Remove the rear quarter trim LH. <Ref. to EI-110, SEDAN MODEL, REMOVAL, Rear Quarter Trim.> 2) Remove the radio antenna amplifier assembly. Disconnect the connector. Remove the bolts, and then remove the radio antenna amplifier assem

 Front Wiper Motor and Link

A: REMOVAL 1) Disconnect the ground cable from battery. 2) Remove the front wiper arm assembly. CAUTION: Follow the steps below when standing up the wiper arm. Not following the steps may cause contacting of wiper arms and damages of wiper arms. 1. Stand up the driver's side wiper arm. 2. Stand u

© 2010-2026 Copyright www.suoutback.com