Subaru Outback (BR): Service mode
In service mode, the remote engine start function is temporarily disabled to prevent the system from unexpectedly starting the engine while being serviced.
To engage or disengage service mode:
1. Enter the vehicle and close all vehicle doors and the trunk/rear gate.
2. Verify that the select lever is in the “P” position (AT and CVT models)
3. Depress and hold the brake pedal
4. Turn the ignition switch to the “ON” position
5. Press and release the remote engine start transmitter “
”
button three times. The system will honk the vehicle’s horn each time the button
is pressed.
6. The system will pause for 1 second then honk the vehicle’s horn three times to indicate that the service mode has been engaged or honk one time to indicate that the service mode has been disengaged.
NOTE
When taking your vehicle in for service, it is recommended that you inform the service personnel that your vehicle is equipped with a remote engine start system.
READ NEXT:
Remote transmitter program
New transmitters can be programmed to the remote engine start system in the event
that a transmitter is lost, stolen, damaged or additional transmitters are desired
(the system will accept up to e
System maintenance
NOTE
In the event that the vehicle’s battery is replaced, discharged or disconnected,
it will be necessary to start the vehicle a minimum of one time using the key prior
to activating the remot
Changing the batteries
CAUTION
● Do not let dust, oil or water get on or in the remote engine start transmitter
when replacing the battery.
● Be careful not to damage the printed circuit board in the remote
SEE MORE:
Basic Diagnostic Procedure of Body Control System
A: PROCEDURE
CAUTION:
Subaru Select Monitor is required for reading DTC, performing diagnosis and reading current data.
Remove foreign matter (dust, water, oil, etc.) from the body integrated unit connector during removal and installation.
Registration of the immobilizer is ne
Hazard warning flasher
The hazard warning flasher is used to warn other drivers when you have to park
your vehicle under emergency conditions. The hazard warning flasher works with the
ignition switch in any position.
To turn on the hazard warning flasher, press the hazard warning button on the
instrument panel.
