Subaru Outback (BR): Catalytic converter
WARNING
● Avoid fire hazards. Do not drive or park the vehicle anywhere near flammable materials (e.g. grass, paper, rags or leaves), because the catalytic converter operates at very high temperatures.
● Keep everyone and flammable materials away from the exhaust pipe while the engine is running. The exhaust gas is very hot.
2.5 L non-turbo models
2.5 L turbo models
3.6 L models
The catalytic converter is installed in the exhaust system. It serves as catalyst to reduce HC, CO and NOx in exhaust gases, thus providing cleaner exhaust.
To avoid damage to the catalytic converter:
● Use only unleaded gasoline. Even a small amount of leaded gasoline will damage the catalytic converter.
● Never start the engine by pushing or pulling the vehicle.
● Avoid racing the engine.
● Never turn off the ignition switch while the vehicle is moving.
● Keep your engine tuned-up. If you feel the engine running rough (misfiring, backfiring or incomplete combustion), have your vehicle checked and repaired by an authorized SUBARU dealer.
● Do not apply undercoating or rust prevention treatment to the heat shield of catalytic converter and the exhaust system.
● Do not drive with an extremely low fuel level.
READ NEXT:
Periodic inspections
To keep your vehicle in the best condition at all times, always have the recommended
maintenance services listed in the maintenance schedule in the “Warranty and Maintenance
Booklet” performed
Driving tips for AWD vehicles
WARNING
● Always maintain a safe driving speed according to the road and weather conditions
in order to avoid having an accident on a sharp turn, during sudden braking or under
other simila
SEE MORE:
Automatic Transmission Assembly
A: REMOVAL
1) Remove the front wheels.
2) Fully open the front hood.
3) Disconnect the ground cable from battery.
4) Remove the collector cover.
NOTE:
Follow the steps below when removing the collector
cover.
Pull up the two points at the rear (A).
Pull up the two points at the front (B) whil
Wear indicators
1) New tread
2) Worn tread
3) Tread wear indicator
Each tire incorporates a tread wear indicator, which becomes visible when the
depth of the tread grooves decreases to 0.063 in (1.6 mm). A tire must be replaced
when the tread wear indicator appears as a solid band across the tread.
WARNIN
