Subaru Outback (BR): When you do not tow a trailer
Subaru Outback (BR) 2010-2015 Owners Manual / Driving tips / Trailer hitch (Outback — if equipped) / When you do not tow a trailer
● Remove the ball mount from the hitch receiver tube and insert the receiver cover onto the hitch receiver tube.
● Place the dust cap over the four-pin connector of the hitch wire harness to protect against possible damage.
● Occasionally lubricate terminals of the four-pin connector using terminal grease.
READ NEXT:
Trailer towing
Your vehicle is designed and intended to be used primarily as a passenger-carrying
vehicle. Towing a trailer puts additional loads on your vehicle’s engine, drivetrain,
brakes, tires and suspens
Warranties and maintenance
vehicle damage or malfunction caused by trailer towing. If you use your vehicle
to tow a trailer, more frequent maintenance will be required due to the additional
load. (Refer to “Maintenance sc
Maximum load limits
WARNING
Never exceed the maximum load limits explained in the following. Exceeding the
maximum load limits could cause personal injury and/or vehicle damage.
CAUTION
● Adequate size trailer
SEE MORE:
Shift Link Assembly
A: REMOVAL
1) Remove the manual transmission assembly
from the vehicle. <Ref. to 6MT-25, REMOVAL,
Manual Transmission Assembly.>
2) Remove the back-up light switch and the neutral
position switch. <Ref. to 6MT-37, REMOVAL,
Switches and Harness.>
3) Remove the transfer case together wit
Brake Hose
A: REMOVAL
1. FRONT BRAKE HOSE
1) Separate the brake pipe (b) from brake hose (a) using a flare nut wrench.
2) Remove the clamp, strut mounting bolt and union bolt, and remove the front
brake hose.
2. REAR BRAKE HOSE
1) Remove the brake hose bracket bolt and union bolt.
2) Separate the brake pip
© 2010-2026 Copyright www.suoutback.com
