Subaru Outback manuals

Subaru Outback (BR): Windshield wiper blade rubber

Subaru Outback (BR) 2010-2015 Owners Manual / Maintenance and service / Replacement of wiper blades / Windshield wiper blade rubber

1) Support


1) Support

1. Grasp the locked end of the blade rubber assembly and pull it firmly until the stoppers on the rubber are free of the support.

1) Metal spines


1) Metal spines

2. If the new blade rubber is not provided with two metal spines, remove the metal spines from the old blade rubber and install them in the new blade rubber.

3. Align the claws of the support with the grooves in the rubber and slide the


3. Align the claws of the support with the grooves in the rubber and slide the blade rubber assembly into the support until it locks.

1) Claw


1) Claw
2) Stopper

4. Be sure to position the claws at the end of the support between the stoppers on the rubber as shown. If the rubber is not retained properly, the wiper blade may scratch the windshield.

READ NEXT:

 Rear window wiper blade assembly (Outback)

1. Raise the wiper arm off the rear window. 2. Turn the wiper blade assembly counterclockwise. 3. Pull the wiper blade assembly toward you to remove it from the wiper arm.

 Rear window wiper blade rubber (Outback)

1. Pull out the end of the blade rubber assembly to unlock it from the plastic support. 2. Pull the blade rubber assembly out of the plastic support. 1) Metal spines 3. If the new blade rub

 Battery charging, fluid level

Before starting any work near a battery, it's crucial to ensure that all sources of ignition, such as cigarettes, matches, and lighters, are completely extinguished. This precaution is vital because b

SEE MORE:

 Trailer safety chains

WARNING Always use safety chains between your vehicle and the trailer. Towing trailer without safety chains could create a traffic safety hazard if the trailer separates from the hitch due to coupling damage or hitch ball damage. In case the trailer hitch connector or hitch ball should break or

 Fuel gauge

1) Low fuel warning light The fuel gauge shows the approximate amount of fuel remaining in the tank. When the ignition switch is in the “LOCK” or “Acc” position, the fuel gauge shows “E” even if the fuel tank contains fuel. The gauge may move slightly during braking, turning or a

© 2010-2026 Copyright www.suoutback.com