Subaru Outback (BR): Arming the system (remote transmitter and power door locking switch)
READ NEXT:
1. Close all windows and the moonroof (if equipped).
2. Remove the key from the ignition switch.
3. Open the doors and get out of the vehicle.
4. Make sure that the engine hood (and the trunk lid (
1. Close all windows.
2. Remove the key from the ignition switch.
3. Open the doors and get out of the vehicle.
4. Make sure that the engine hood is locked.
5. Close the doors (and the rear gate (
Briefly press the “” button (for
less than 2 seconds) on the remote transmitter. The driver’s door will unlock, an
electronic chirp will sound twice, the turn signal lights will flash twice
SEE MORE:
CAUTION
In passive mode, the system will automatically activate the alarm but WILL NOT
automatically lock the doors. In order to lock the doors you must either lock them
as indicated in step 4 below or with the key once they have been closed. Failure
to lock the doors manually will result in
A: LOCATION
NOTE: For other related fuses, refer to the wiring diagram. <Ref. to WI-15, Power Supply Circuit.>
B: INSPECTION
1. CHECK FUSE.
1) Remove the fuse and check visually.
2) If the fuse is blown out, replace the fuse.
2. CHECK RELAY
1) Check the resistance between relay ter
© 2010-2026 Copyright www.suoutback.com
