Subaru Outback manuals

Subaru Outback (BR): Arming the system (remote transmitter and power door locking switch)

Subaru Outback (BR) 2010-2015 Owners Manual / Keys and doors / Alarm system / Arming the system (remote transmitter and power door locking switch)

READ NEXT:

 To arm the system using remote transmitter

1. Close all windows and the moonroof (if equipped). 2. Remove the key from the ignition switch. 3. Open the doors and get out of the vehicle. 4. Make sure that the engine hood (and the trunk lid (

 To arm the system using power door locking switch

1. Close all windows. 2. Remove the key from the ignition switch. 3. Open the doors and get out of the vehicle. 4. Make sure that the engine hood is locked. 5. Close the doors (and the rear gate (

 Disarming the system

Briefly press the “” button (for less than 2 seconds) on the remote transmitter. The driver’s door will unlock, an electronic chirp will sound twice, the turn signal lights will flash twice

SEE MORE:

 Front Hood

A: REMOVAL 1. FRONT HOOD INSULATOR Release the clips to remove the front hood insulator. CAUTION: Do not reuse any clips damaged during removal. The damaged clip cannot fix the insulator securely. Therefore, always replace with a new part. 2. FRONT HOOD SEAL Remove the clip, and remove the seal.

 Cooling or dehumidifying

For cooling and dehumidification of the passenger compartment, air flows through the instrument panel outlets: 1. Set the air inlet selection button to the OFF position. 2. Press the “” button. 3. Set the air conditioner button to the “ON” position. 4. Set the temperature control dial

© 2010-2026 Copyright www.suoutback.com