Subaru Outback: Category selection

To activate the category search mode, press the “PTY/CAT” button. To deactivate
the category search mode, press the “PTY/CAT” button again.

When in the category search mode, pressing the “FOLDER” button “
”
changes the category up by one step. Pressing “
”
changes the category down by one step.
When a category is selected, pressing the “SEEK” button selects channels only
within the selected category.
The control function returns to the normal mode after approximately 10 seconds.
READ NEXT:
If you press the “SCAN” button while the radio is in the category search mode,
the radio turns to the category SCAN mode. In the category SCAN mode, the radio
scans only channels in the sele
How to preset channels
1. Press the “SAT” button to select SAT1, SAT2 and SAT3 reception.
2. Select the desired channel.
3. Press one of the preset buttons for more than 1.5 seconds to store th
SEE MORE:
A: REMOVAL
1) Disconnect the ground cable from battery.
2) Remove the rear door trim. <Ref. to EI-61, REAR DOOR, REMOVAL, Door Trim.>
3) Remove the rear door speaker assembly.
Remove the screws.
Disconnect the harness connector and remove the rear speaker assembly.
4) Remove the rear se
Talk switch
To turn on the voice command system, press the talk switch
briefly. To turn off the voice command
system, press the talk switch for more
than 1.5 seconds.
The commands available for the voice command system are listed in the following
chart.
© 2010-2023 Copyright www.suoutback.com
