Subaru Outback (BR): Preset buttons
Subaru Outback (BR) 2010-2015 Owners Manual / Audio / Satellite radio operation (if equipped) / Channel preset / Preset buttons
How to preset channels
1. Press the “SAT” button to select SAT1, SAT2 and SAT3 reception.
2. Select the desired channel.
3. Press one of the preset buttons for more than 1.5 seconds to store the channel. If the button is pressed for less than 1.5 seconds, the preceding selection will remain in memory.
NOTE
If the connection between the radio and battery is broken for any reason such as vehicle maintenance or radio removal, all channels stored in the preset buttons are cleared. If this occurs, it is necessary to reset the preset channels.
READ NEXT:
Selecting preset channels
Presetting a channel with a preset button allows you to select that channel in
a single operation. Up to six SAT1, SAT2 and SAT3 channels each may be preset.
Display selection in satellite radio
Press the “TEXT” button while receiving the satellite radio to change the display as follows:
CD player operation
NOTE
● Make sure to always insert a disc with the label side up. If a disc is inserted
with the label side down, the player displays “CHECK DISC”. Refer to “When the following
message
SEE MORE:
Basic Diagnostic Procedure of Airbag System
A: PROCEDURE
Check List for Interview
A: CHECK
Identification
A: PROCEDURE
Identify the vehicle using the chassis number, part number of the airbag control module or Subaru Select Monitor.
NOTE: Proper identification is necessary to ensure proper diagnosis. Components are not interchange
A/C – Air conditioner button
If the windshield starts to fog when the climate control system is operated in
the AUTO mode, press the air conditioner button “A/C” to defog and dehumidify. When
this button is pressed, the air conditioner compressor turns on and the indicator
light “A/C” on the display illuminates.
© 2010-2026 Copyright www.suoutback.com
