Subaru Outback (BR): Cruise control set indicator light
Subaru Outback (BR) 2010-2015 Owners Manual / Instruments and controls / Warning and indicator lights / Cruise control set indicator light
The cruise control set indicator light illuminates when the ignition switch is turned to the “ON” position and turns off after approximately 3 seconds.
This light illuminates when vehicle speed has been set.
READ NEXT:
Headlight indicator light
This indicator light illuminates under the following conditions.
● when the light switch is turned to the “”
or “” position
● when the light switch is in the “AUTO” posit
Front fog light indicator light (if equipped)
This indicator light illuminates while the front fog lights are illuminated.
Clock
NOTE
Your SUBARU dealer can change the settings of activating/deactivating the automatic
adjustment of the clock by the GPS (Global Positioning System) (for models with
the genuine SUBARU navigat
SEE MORE:
Front Vehicle Speed Sensor
A: REMOVAL
1) Remove the transmission assembly from the vehicle.
<Ref. to 5AT-37, REMOVAL, Automatic
Transmission Assembly.>
2) Disconnect the rear vehicle speed sensor connector.
NOTE:
Secure the transmission harness to the transmission
body using wire etc.
3) Remove the extension case.
Using the cover
To extend the cover, pull the end of the cover out of the housing, then insert
its hooks into the catches as shown. To rewind it, unhook it from the catches and
it will rewind automatically. You should hold on to the cover and guide it back
into the cover housing while it is rewinding.
WARN
© 2010-2026 Copyright www.suoutback.com
