Subaru Outback manuals

Subaru Outback: For AT models

This light flashes if the vehicle is driven with tires of different diameters fitted on its wheels or with the air pressure excessively low in any of its tires.

READ NEXT:

 For CVT models

This light illuminates when All-Wheel Drive is disengaged and the drive mechanism is switched to Front Wheel Drive for maintenance or similar purposes. This light flashes if the vehicle is driven

 Vehicle Dynamics Control warning light/Vehicle Dynamics Control operation indicator light

The light illuminates when the ignition switch is turned to the “ON” position and turns off several seconds after the engine has started. This lighting pattern indicates that the Vehicle Dynam

 Vehicle Dynamics Control warning light

CAUTION The Vehicle Dynamics Control system provides its ABS control through the electrical circuit of the ABS system. Accordingly, if the ABS is inoperative, the Vehicle Dynamics Control system

SEE MORE:

 Lubricants

Engine oil For the checking, adding and replacing procedure or other details, refer to “Engine oil” F11-12. NOTE The procedure for changing the engine oil and oil filter should be performed by a properly-trained expert. It is recommended that you have this service performed by your SUBA

 Ignition Switch Illumination

A: REMOVAL 1) Disconnect the ground cable from battery. 2) Remove the steering column cover. Remove the screws by turning the steering wheel to right and left. Release the claws and remove the steering column lower cover. Separate the steering column upper cover and steering upper cover,

© 2010-2023 Copyright www.suoutback.com