Subaru Outback (BR): For CVT models
This light illuminates when All-Wheel Drive is disengaged and the drive mechanism is switched to Front Wheel Drive for maintenance or similar purposes. This light flashes if the vehicle is driven with tires of different diameters fitted on its wheels or with the air pressure excessively low in any of its tires.
READ NEXT:
VDC warning light / VDC operation indicator light
The light illuminates when the ignition switch is turned to the “ON” position and turns off several seconds after the engine has started. This lighting pattern indicates that the Vehicle
Vehicle Dynamics Control warning light
CAUTION
The Vehicle Dynamics Control system provides its ABS control through the electrical
circuit of the ABS system. Accordingly, if the ABS is inoperative, the Vehicle Dynamics
Control system
Vehicle Dynamics Control operation indicator light
The indicator light flashes during activation of the skid suppression function
and during activation of the traction control function.
NOTE
● The light may remain illuminated for a short per
SEE MORE:
Certification for the Hands-free system
NOTE
● This device complies with Part 15 of the FCC Rules and with RSS-Gen of IC Rules.
Operation is subject to the following two conditions: (1) This device may not cause
harmful interference, and (2) this device must accept any interference received,
including interference that may ca
Crankshaft Position Sensor
A: REMOVAL
1) Disconnect the ground cable from battery.
2) Remove the bolt which secures crankshaft position
sensor to oil pump.
3) Remove the crankshaft position sensor, and disconnect
the connector from the crankshaft position
sensor.
B: INSTALLATION
Install in the reverse order of removal.
Tig
© 2010-2026 Copyright www.suoutback.com
