Subaru Outback (BR): Front position light
Subaru Outback (BR) 2010-2015 Owners Manual / Maintenance and service / Replacing bulbs / Front position light
1. Turn the socket counterclockwise and pull it out.
2. Pull out the bulb from the socket and replace the bulb with a new one.
READ NEXT:
Front fog light (if equipped)
NOTE
It may be difficult to replace the bulbs. We recommend that you have the bulbs
replaced by your SUBARU dealer if necessary.
1. Pull off the fender lining. Refer to “Pulling off the fender l
Rear combination lights
Legacy
NOTE
It may be difficult to replace the bulbs. We recommend that you have the bulbs
replaced by your SUBARU dealer if necessary.
1. Turn the knobs of the cover 90 degrees counterclockwis
Tail/Back-up light (Outback)
1. Apply a flat-head screwdriver to the light cover as shown in the illustration,
and pry the light cover off from the rear gate trim.
1) Back-up light
2) Tail light
2. Turn the bulb socket c
SEE MORE:
Shock sensors (dealer option)
The shock sensors trigger the alarm system when they sense impacts applied to
the vehicle and when any of their electric wires is cut. The alarm system causes
the horn to sound and the turn signal lights to flash for a short time when the
sensed impact is weak, but it warns of a strong impact
Ignition
General Description
A: SPECIFICATION
B: COMPONENT
Spark plug
Ignition coil
Tightening torque: N*m (kgf-m, ft-lb)
T1: 9 (0.9, 6.6)
T2: 21 (2.1, 15.5)
C: CAUTION
Wear appropriate work clothing, including a cap, protective goggles and
protective shoes when performing
any work.
Remove contam
© 2010-2026 Copyright www.suoutback.com
