Subaru Outback (BR): Heating and defrosting
Subaru Outback (BR) 2010-2015 Owners Manual / Climate control / Manual climate control system (if equipped) / Heater operation / Heating and defrosting
To direct warm air toward the floor and the windshield: 1. Set the air inlet selection button to the OFF position.
2. Press the “
” button.
3. Set the temperature control dial to the most comfortable level.
4. Set the fan speed control dial to the desired speed.
READ NEXT:
Heating
To direct warm air toward the floor:
1. Set the air inlet selection button to the OFF position.
2. Press the “” button.
3. Set the temperature control dial to the most comfortable level.
4. Se
Bi-level heating
This setting allows you to direct air of different temperatures from the instrument
panel and foot outlets. The air from the foot outlets is slightly warmer than from
the instrument panel outlets.
Ventilation
To force outside air through the instrument panel outlets:
1. Set the air inlet selection button to the OFF position.
2. Press the “” button.
3. Set the temperature control dial all the way lef
SEE MORE:
ABS warning light
The ABS warning light illuminates when the ignition switch is turned to the “ON”
position and turns off after approximately 2 seconds.
This is an indication that the ABS system is working properly.
CAUTION
● If any of the following conditions occur, we recommend that you have the AB
Rearview Camera System
A: WIRING DIAGRAM
Refer to "Rearview Camera System" in the wiring diagram. <Ref. to WI-213,
WIRING DIAGRAM, Rearview
Camera System.>
B: REMOVAL
1. SEDAN MODEL
1) Disconnect the ground cable from battery.
2) Remove the trunk lid trim.
Remove the trunk handle.
Remove the clips and the trunk
© 2010-2026 Copyright www.suoutback.com
