Subaru Outback (BR): Relay and Fuse, Door Lock Control System
A: LOCATION
NOTE: For other related fuses, refer to the wiring diagram. <Ref. to WI-15, Power Supply Circuit.>
B: INSPECTION
1. CHECK FUSE.
1) Remove the fuse and inspect visually.
2) If the fuse is blown out, replace the fuse.
NOTE: If the fuse is blown again, check the system wiring harness.
Door Lock Control System
A: WIRING DIAGRAM
Refer to "Keyless Entry System" in the wiring diagram. <Ref. to WI-181, WIRING DIAGRAM, Keyless Entry System.>
B: ELECTRICAL SPECIFICATION
1. BODY INTEGRATED UNIT
Refer to "Control Module I/O Signal" of "BODY CONTROL SYSTEM (DIAGNOSTICS)" section. <Ref. to BC(diag)-7, ELECTRICAL SPECIFICATION, Control Module I/O Signal.>
C: INSPECTION
1. SYMPTOM CHART
2. CHECK POWER SUPPLY AND GROUND CIRCUIT
3. CHECK DOOR LOCK SWITCH
4. CHECK REAR GATE/TRUNK OPENER BUTTON SWITCH CIRCUIT
5. CHECK DOOR LOCK ACTUATOR AND CIRCUIT
READ NEXT:
Keyless Entry System
A: WIRING DIAGRAM
Refer to "Keyless Entry System" in the wiring diagram. <Ref. to WI-181,
WIRING DIAGRAM, Keyless Entry
System.>
B: ELECTRICAL SPECIFICATION
1. KEYLESS ENTRY CONTROL MODULE
Mo
Front Inner Remote
A: REMOVAL
1) Remove the door trim. <Ref. to EI-60, REMOVAL, Door Trim.>
2) Remove the screws to detach the front inner remote handle.
B: INSTALLATION
1) Before installation, check the followi
Rear Inner Remote
A: REMOVAL
1) Remove the door trim. <Ref. to EI-60, REMOVAL, Door Trim.>
2) Remove the screws and detach the rear inner remote handle.
B: INSTALLATION
1) Before installation, check the followi
SEE MORE:
Behavior with key lock-in prevention function non-operational
● If the lock lever is turned to the rear (“LOCK”) position with the driver’s
door open and the driver’s door is then closed with the lock lever in that position,
the driver’s door is locked. . If the spare key is used to lock the driver’s door
from the outside of the vehicle
Head restraint adjustment
1) Head restraint
2) Release button
Both the driver’s seat and the front passenger’s seat are equipped with head
restraints.
The head restraint should be adjusted so that the center of the head restraint
is closest to the top of the occupant’s ears.
To raise:
Pull the head restraint
