Subaru Outback (BR): Security and Locks
Subaru Outback (BR) 2010-2015 Service Manual / Body / Security and Locks
- Security General Description
- Relay and Fuse, Door Lock Control System
- Keyless Entry System
- Front Inner Remote
- Rear Inner Remote
- Rear Gate Latch and Actuator Assembly
- Remote Openers
- Key Lock Cylinders
- Keyless Entry Control Module
- Keyless Transmitter
READ NEXT:
Security General Description
A: COMPONENT
1. DOOR LOCK ASSEMBLY
Front
Rear
Inner remote ASSY
Front door latch and door lock actuator ASSY
Door outer handle
Door outer handle cover
Key
Relay and Fuse, Door Lock Control System
A: LOCATION
NOTE: For other related fuses, refer to the wiring diagram. <Ref. to WI-15, Power Supply Circuit.>
B: INSPECTION
1. CHECK FUSE.
1) Remove the fuse and inspect visually.
2)
Keyless Entry System
A: WIRING DIAGRAM
Refer to "Keyless Entry System" in the wiring diagram. <Ref. to WI-181,
WIRING DIAGRAM, Keyless Entry
System.>
B: ELECTRICAL SPECIFICATION
1. KEYLESS ENTRY CONTROL MODULE
Mo
SEE MORE:
Passenger's Airbag Module
A: REMOVAL
CAUTION:
Refer to "CAUTION" of "General Description" before handling the airbag module.
<Ref. to AB-9,
CAUTION, General Description.>
1) Turn the ignition switch to OFF.
2) Disconnect the ground cable from battery and wait for at least 60 seconds
before starting work.
3) Remove
Low tire pressure warning light (U.S.-spec. models)
When the ignition switch is turned to the “ON” position, the low tire pressure
warning light will illuminate for approximately 2 seconds to check that the tire
pressure monitoring system (TPMS) is functioning properly. If there is no problem
and all tires are properly inflated, the light
© 2010-2026 Copyright www.suoutback.com
