Subaru Outback (BR): Headlight
CAUTION
Halogen headlight bulbs become very hot while in use. If you touch the bulb surface with bare hands or greasy gloves, fingerprints or grease on the bulb surface will develop into hot spots, causing the bulb to break. If there are fingerprints or grease on the bulb surface, wipe them away with a soft cloth moistened with alcohol.
NOTE
● If headlight aiming is required, consult your SUBARU dealer for proper adjustment of the headlight aim.
● It may be difficult to replace the bulbs. We recommend that you have the bulbs replaced by your SUBARU dealer if necessary.
READ NEXT:
Low beam light bulbs
1. Pull off the fender lining. For details, refer to “Pulling off the fender
lining” F11- 7.
2. Remove the bulb cover, by turning it counterclockwise.
3. Disconnect the electrical connecto
High beam light bulbs
1. Remove the air intake duct (right-hand side). For the method to remove the
air intake duct, refer to “Removing air intake duct” F11-7.
Left-hand side
2. Use a screwdriver to remove the se
Front turn signal light
NOTE
It may be difficult to replace the bulbs. We recommend that you have the bulbs
replaced by your SUBARU dealer if necessary.
1. Turn over the protective cover of the engine compartment.
2
SEE MORE:
Clock
NOTE
Your SUBARU dealer can change the settings of activating/deactivating the automatic
adjustment of the clock by the GPS (Global Positioning System) (for models with
the genuine SUBARU navigation system). Contact your SUBARU dealer for details.
The clock shows the time while the ignition
Vehicle Dynamics Control warning light
CAUTION
The Vehicle Dynamics Control system provides its ABS control through the electrical
circuit of the ABS system. Accordingly, if the ABS is inoperative, the Vehicle Dynamics
Control system becomes unable to provide ABS control. As a result, the Vehicle Dynamics
Control system also becom
© 2010-2026 Copyright www.suoutback.com
