Subaru Outback manuals

Subaru Outback (BR): High beam light bulbs

1. Remove the air intake duct (right-hand side). For the method to remove the air intake duct, refer to “Removing air intake duct” F11-7.

Left-hand side


Left-hand side

2. Use a screwdriver to remove the secured clip of the washer tank. To make it easy to access the bulb, move the washer tank to the horizontal direction (left-hand side).

3. Disconnect the electrical connector from the bulb.


3. Disconnect the electrical connector from the bulb.

4. Remove the bulb from the headlight assembly by turning it counterclockwise.


4. Remove the bulb from the headlight assembly by turning it counterclockwise.

5. Replace the bulb with new one. At this time, use care not to touch the bulb surface.

6. Reconnect the electrical connector.

7. To install the bulb to the headlight assembly, turn it clockwise until it clicks.

8. Install the air intake duct with clips (right-hand side).

9. Set the washer tank to the original place and secure it by clip (left-hand side).

READ NEXT:

 Front turn signal light

NOTE It may be difficult to replace the bulbs. We recommend that you have the bulbs replaced by your SUBARU dealer if necessary. 1. Turn over the protective cover of the engine compartment. 2

 Front position light

1. Turn the socket counterclockwise and pull it out. 2. Pull out the bulb from the socket and replace the bulb with a new one.

 Front fog light (if equipped)

NOTE It may be difficult to replace the bulbs. We recommend that you have the bulbs replaced by your SUBARU dealer if necessary. 1. Pull off the fender lining. Refer to “Pulling off the fender l

SEE MORE:

 Heater operation

NOTE ● When the “” button or “” button is pressed the air conditioner compressor automatically operates to quickly defog the windshield. However the indicator on the air conditioner button will not illuminate. At the same time, the air inlet selection is automatically set to “

 How to re-stow bars

CAUTION Do not use the bars as roof rails when the bars are stowed. 1. Pull out the crossbars from the roof rail holders by pulling up the covers. 2. Slide the bars in the direction shown in the illustration. 3. Install the bars into the holders. 4. Make sure that the latches are fitted s

© 2010-2026 Copyright www.suoutback.com