Subaru Outback (BR): Front turn signal light
Subaru Outback (BR) 2010-2015 Owners Manual / Maintenance and service / Replacing bulbs / Front turn signal light
NOTE
It may be difficult to replace the bulbs. We recommend that you have the bulbs replaced by your SUBARU dealer if necessary.
1. Turn over the protective cover of the engine compartment.
2. Turn the socket counterclockwise and pull it out.
3. Pull out the bulb from the socket and replace the bulb with a new one.
4. After replacing the bulbs, reposition the protective cover of the engine compartment.
READ NEXT:
Front position light
1. Turn the socket counterclockwise and pull it out.
2. Pull out the bulb from the socket and replace the bulb with a new one.
Front fog light (if equipped)
NOTE
It may be difficult to replace the bulbs. We recommend that you have the bulbs
replaced by your SUBARU dealer if necessary.
1. Pull off the fender lining. Refer to “Pulling off the fender l
Rear combination lights
Legacy
NOTE
It may be difficult to replace the bulbs. We recommend that you have the bulbs
replaced by your SUBARU dealer if necessary.
1. Turn the knobs of the cover 90 degrees counterclockwis
SEE MORE:
Select Lever (removal, installation, disassembly, inspection)
A: REMOVAL
1) Shift the select lever to "N" range.
2) Disconnect the ground cable from battery.
3) Lift up the vehicle.
4) Remove the rear exhaust pipe.
2.5 L non-turbo model <Ref. to EX(H4SO)-9, REMOVAL, Rear Exhaust Pipe.>
3.6 L model <Ref. to EX(H6DO)-8, REMOV
Operating Cylinder
A: REMOVAL
NOTE:
The illustration below is suitable for every model.
Perform the same procedures for the other models.
1) Remove the collector cover. (turbo model)
2) Remove the air intake boot assembly. (non-turbo
model) <Ref. to IN(H4SO)-8, REMOVAL, Air Intake
Boot.>
3) Remove the interc
© 2010-2026 Copyright www.suoutback.com
