Subaru Outback (BR): Security ID plate
1) Key number plate
2) Security ID plate
The security ID is stamped on the security ID plate attached to the key set. Write down the security ID and keep it in another safe place, not in the vehicle. This number is needed to make a replacement key if you lose your key or lock it inside the vehicle.
To make replacement keys, the key number is also needed. Refer to “Key replacement” F2-4.
The security ID is also needed for replacement or repair of the engine control unit, integrated unit, combination meter (all models) and security control unit (Canada-spec. models).
READ NEXT:
Security indicator light
The security indicator light deters potential thieves by indicating that the
vehicle is equipped with an immobilizer system. It begins flashing approximately
60 seconds after the ignition switch
Key replacement
Your key number plate and security ID plate will be required if you ever need
a replacement key made. Any new key must be registered for use with your vehicle’s
immobilizer system before it can
SEE MORE:
General Description of Fuel Injection System
A: SPECIFICATION
B: COMPONENT
1. INTAKE MANIFOLD
Intake manifold
Gasket
Intake manifold protector RH
Intake manifold protector LH
Fuel gallery RH
Fuel gallery LH
Fuel pipe
Fuel delivery pipe
Injector
Seal ring
Cap
Clip
O-ring
Map light bulb replacing
1. Remove the lens by prying the edge of the lens with a flat-head screwdriver.
2. Turn the bulb until the flat surfaces at its ends are aligned vertically. Pull the bulb straight downward to remove it.
3. Install a new bulb.
4. Reinstall the lens.
© 2010-2026 Copyright www.suoutback.com
