Subaru Outback (BR): AT OIL TEMP warning light (AT and CVT models)
Subaru Outback (BR) 2010-2015 Owners Manual / Instruments and controls / Warning and indicator lights / AT OIL TEMP warning light (AT and CVT models)
The AT oil temperature warning light “AT OIL TEMP” illuminates when the ignition switch is turned to the “ON” position and turns off after approximately 2 seconds. If this light illuminates when the engine is running, it may indicate that the transmission fluid temperature is too hot. If the light illuminates while driving, immediately stop the vehicle in a safe place and let the engine idle until the warning light turns off.
READ NEXT:
Transmission control system warning
If the “AT OIL TEMP” warning light flashes after the engine has started, it may
indicate that the transmission control system is not working properly. Contact your
nearest SUBARU dealer for se
Low tire pressure warning light (U.S.-spec. models)
When the ignition switch is turned to the “ON” position, the low tire pressure
warning light will illuminate for approximately 2 seconds to check that the tire
pressure monitoring system (TP
Understanding the ABS Warning Light in Your Subaru Outback (BR)
ABS warning light serves as an essential indicator of the Anti-Lock Braking System's operational status in your Subaru Outback (BR). When you turn the ignition switch to the “ON”
SEE MORE:
Yaw Rate and G Sensor
A: NOTE
Yaw rate & longitudinal G and lateral G sensor are integrated with the VDC
control module & hydraulic control
module (VDCCM&H/U).
B: INSPECTION
1. YAW RATE & LONGITUDINAL G AND LATERAL G SENSOR SIGNAL
Steering Angle Sensor
A: REPLACEMENT
1) Position the front wheels straigh
Rear Differential (VA-type)
A: REMOVAL
The removal procedure for VA-type is included in
"REMOVAL" for T-type. <Ref. to DI-26, REMOVAL,
Rear Differential (T-type).>
B: INSTALLATION
The installation procedure for VA-type is included
in "INSTALLATION" for T-type. <Ref. to DI-28, INSTALLATION,
Rear Differential (T-type).&
© 2010-2026 Copyright www.suoutback.com
