Subaru Outback (BR): High beam indicator light
Subaru Outback (BR) 2010-2015 Owners Manual / Instruments and controls / Warning and indicator lights / High beam indicator light
This light shows that the headlights are in the high beam mode.
This indicator light also illuminates when the headlight flasher is operated.
READ NEXT:
Indicator light for cruise control in Outback (2010-2015)
The indicator light for cruise control becomes illuminated upon turning the ignition switch to the “ON” position and remains lit for around 3 seconds. Activation of this light al
Cruise control set indicator light
The cruise control set indicator light illuminates when the ignition switch is
turned to the “ON” position and turns off after approximately 3 seconds.
This light illuminates when vehicle spe
Headlight indicator light
This indicator light illuminates under the following conditions.
● when the light switch is turned to the “”
or “” position
● when the light switch is in the “AUTO” posit
SEE MORE:
Wear indicators
1) New tread
2) Worn tread
3) Tread wear indicator
Each tire incorporates a tread wear indicator, which becomes visible when the
depth of the tread grooves decreases to 0.063 in (1.6 mm). A tire must be replaced
when the tread wear indicator appears as a solid band across the tread.
WARNIN
Cruise control
Cruise control enables you to maintain a constant vehicle speed without holding
your foot on the accelerator pedal and it is operative when the vehicle speed is
25 mph (40 km/h) or more.
WARNING
Do not use the cruise control under any of the following conditions. These may
cause loss of vehi
© 2010-2026 Copyright www.suoutback.com
