Subaru Outback (BR): Temperature sensors
Subaru Outback (BR) 2010-2015 Owners Manual / Climate control / Automatic climate control system (if equipped) / Temperature sensors
1) Solar sensor
2) Interior air temperature sensor
The automatic climate control system employs several sensors. These sensors are delicate. If they are treated incorrectly and become damaged, the system may not be able to control the interior temperature correctly. To avoid damaging the sensors, observe the following precautions:
– Do not subject the sensors to impact.
– Keep water away from the sensors.
– Do not cover the sensors.
The sensors are located as follows:
– Solar sensor: beside the speaker grille on the dashboard
– Interior air temperature sensor: on the side of the driver-side part of the center
panel
– Outside temperature sensor: behind front grille.
READ NEXT:
Cleaning ventilator grille
Always keep the front ventilator inlet grille free of snow, leaves, or other
obstructions to ensure efficient heating and defrosting. Since the condenser is
located in front of the radiator, thi
Efficient cooling after parking in direct sunlight
After parking in direct sunlight, drive with the windows open for a few minutes
to allow outside air to circulate into the heated interior. This results in quicker
cooling by the air conditioner.
SEE MORE:
Connecting a trailer
1. Remove the receiver cover from the hitch receiver tube. Then insert the ball
mount into the hitch receiver tube.
2. Insert the hitch pin into the hole on the hitch receiver tube so that the
pin passes through the ball mount.
3. Insert the safety pin onto the hitch pin securely.
4. Pull
Switches and Harness in Manual Transmission
A: REMOVAL
1. BACK-UP LIGHT AND NEUTRAL POSITION SWITCH
1) Disconnect the ground cable from battery.
2) Remove the collector cover. (turbo model)
3) Remove the air intake boot assembly. (non-turbo model) <Ref. to IN(H4SO)-8, REMOVAL, Air Intake Boot.>
4) Remove the intercooler. (turbo mod
© 2010-2026 Copyright www.suoutback.com
