Subaru Outback (BR): Skip channel selection

When in the SAT mode, press the “SEEK” button “
”
or “
” continuously to change to the
channel selection mode. Pressing the “SEEK” button “
”
changes the channel up by 10 steps each time. Pressing “
”
changes the channel down by 10 steps each time.
READ NEXT:
To activate the category search mode, press the “PTY/CAT” button. To deactivate
the category search mode, press the “PTY/CAT” button again.
When in the category search mode, pressing th
If you press the “SCAN” button while the radio is in the category search mode,
the radio turns to the category SCAN mode. In the category SCAN mode, the radio
scans only channels in the sele
SEE MORE:
It is necessary to pull off the fender lining when replacing some bulbs.
1. Start the engine and turn the steering wheel fully in the opposite direction
of the bulb to be replaced.
2. Stop the engine.
3. Remove the clip from the fender lining. Refer to “Type B clips” F11-5.
4. Pull off
A: REMOVAL
1. TRUNK LID DAMPER STAY
1) Open the trunk lid.
2) Remove the trunk lid damper stay.
Float the lock pin using a flat tip screwdriver, etc. and slide it.
Remove the trunk lid damper stay by pulling the damper stay mounting
point.
2. TRUNK LID HINGE
1) Open the trunk lid.
2) Remove
© 2010-2026 Copyright www.suoutback.com
