Subaru Outback (BR): To remove the cover housing
Subaru Outback (BR) 2010-2015 Owners Manual / Interior equipment / Cargo area cover (if equipped) / To remove the cover housing
1. Rewind the cover.
2. Hold down the button on the righthand rear quarter panel and lift up the right-hand cover housing.
3. Remove the cover housing.
READ NEXT:
Stowage of the cargo area cover
The cargo area cover can be stowed in under the cargo floor.
1. To open the lid, pull the handle up.
2. To keep the lid open, hang the hook (provided on the back of the lid) on the
rear edge o
To install the cover housing
1. To install the cover housing, insert both ends of the cover housing into the
retainers.
2. Make sure to fix the front part of the cargo area cover behind the rear seat.
Convenient tie-down hooks (if equipped)
CAUTION
The convenient tie-down hooks are designed only for securing light cargo. Never
try to secure cargo that exceeds the capacity of the hooks. The maximum load capacity
is 44 lbs (20 kg) per
SEE MORE:
Combination Switch (Light)
A: REMOVAL
1) Position the front wheels straight ahead. (After moving a vehicle 5 m (16
ft) or more with front wheels positioned
straight ahead, make sure that the vehicle moves straight ahead.)
2) Turn the ignition switch to OFF.
3) Disconnect the ground cable from battery and wait for at least
Certification for the Hands-free system
NOTE
● This device complies with Part 15 of the FCC Rules and with RSS-Gen of IC Rules.
Operation is subject to the following two conditions: (1) This device may not cause
harmful interference, and (2) this device must accept any interference received,
including interference that may ca
© 2010-2026 Copyright www.suoutback.com
