Subaru Outback (BR): Selecting reverse gear
Subaru Outback (BR) 2010-2015 Owners Manual / Starting and operating / Manual transmission / Selecting reverse gear
CAUTION
Shift into reverse ONLY when the vehicle has completely stopped. It may cause damage to the transmission to try shifting into reverse when the vehicle is moving.
1) Slider
You must raise the slider and hold it in that position before you can move the shift lever to the “R” position.
To change gears, fully depress the clutch pedal, move the shift lever, and gradually let up on the clutch pedal.
If it is difficult to shift into gear, put the transmission in neutral, release the clutch pedal momentarily, and then try again.
READ NEXT:
Recommended shifting speeds
The best compromise between fuel economy and vehicle performance during normal
driving is ensured by shifting up at the speeds listed in the following table.
Maximum allowable speeds
WARNING
When shifting down a gear, ensure that the vehicle is not travelling at a speed
exceeding the Maximum Allowable Speed for the gear which is about to be selected.
Failure to observe this p
SEE MORE:
General Description of Drive Shaft System
A: SPECIFICATION
1. PROPELLER SHAFT
2. FRONT DRIVE SHAFT ASSEMBLY
Axle diameter
Axle length
3. REAR DRIVE SHAFT ASSEMBLY
Axle diameter
Axle length
B: COMPONENT
1. PROPELLER SHAFT
Propeller shaft
Rear differential (VA1-type)
Rear differe
Valet mode
When you choose the valet mode, the alarm system does not operate. In valet mode,
the remote transmitter is used only for locking and unlocking the doors and rear
gate (Outback) and panic activation.
To enter the valet mode, change the setting of your vehicle’s alarm system for
deactivation
© 2010-2026 Copyright www.suoutback.com
