Subaru Outback (BR): How to re-stow bars
Subaru Outback (BR) 2010-2015 Owners Manual / Driving tips / Loading your vehicle / Roof rails with integrated crossbars (Outback) / How to re-stow bars
CAUTION
Do not use the bars as roof rails when the bars are stowed.
1. Pull out the crossbars from the roof rail holders by pulling up the covers.
2. Slide the bars in the direction shown in the illustration.
3. Install the bars into the holders.
4. Make sure that the latches are fitted securely.
READ NEXT:
Trailer hitch (Outback — if equipped)
WARNING
● Never exceed the maximum weight specified for the trailer hitch. Exceeding
the maximum weight could cause an accident resulting in serious personal injuries.
Permissible trailer w
Connecting a trailer
1. Remove the receiver cover from the hitch receiver tube. Then insert the ball
mount into the hitch receiver tube.
2. Insert the hitch pin into the hole on the hitch receiver tube so that the
When you do not tow a trailer
● Remove the ball mount from the hitch receiver tube and insert the receiver
cover onto the hitch receiver tube.
● Place the dust cap over the four-pin connector of the hitch wire harne
SEE MORE:
Oil Pressure System
A: WIRING DIAGRAM
B: INSPECTION
Engine Oil
A: INSPECTION
CAUTION:
If the engine oil is spilt over exhaust pipe or the
under cover, wipe it off with cloth to avoid emitting
smoke or causing a fire.
1) Park the vehicle on a level surface.
2) Remove the oil level gauge and wipe away the
oil.
3) Rei
Manual Transmission Mounting System
A: REMOVAL
1. CROSSMEMBER AND CUSHION RUBBER
1) Disconnect the ground cable from battery.
2) Lift up the vehicle.
3) Remove the front under cover. <Ref. to EI-35, REMOVAL, Front Under Cover.>
4) Remove the front and center exhaust pipes. (non-turbo model) <Ref. to EX(H4SO)-5, REMOVAL,
© 2010-2026 Copyright www.suoutback.com
