Subaru Outback (BR): Maintenance tips
Subaru Outback (BR) 2010-2015 Owners Manual / Maintenance and service / Maintenance tips
Some clips and fender linings must be removed before replacing the air cleaner elements or specific bulbs.
READ NEXT:
Removing and reinstalling clips
Removing clips
There are several types of clips used for your vehicle
Type A clips
1. Turn the clips counterclockwise using a flat-head screwdriver until the center
portion of the clip is raise
Removing air intake duct
Use a screwdriver to undo the clips on the air intake duct, then remove the air
intake duct. Refer to “Type A clips” F11-5.
Pulling off the fender lining
It is necessary to pull off the fender lining when replacing some bulbs.
1. Start the engine and turn the steering wheel fully in the opposite direction
of the bulb to be replaced.
2. Stop the eng
SEE MORE:
High beam light bulbs
1. Remove the air intake duct (right-hand side). For the method to remove the
air intake duct, refer to “Removing air intake duct” F11-7.
Left-hand side
2. Use a screwdriver to remove the secured clip of the washer tank. To make it
easy to access the bulb, move the washer tank to the hor
Tone and balance control
Each brief press of the “TUNE/TRACK/ CH” dial changes the control modes in the
following sequence.
Choose the desired level for each mode by turning the “TUNE/TRACK/CH” dial. The
control function returns to the tune/ track/channel control mode after approximately
5 seconds.
© 2010-2026 Copyright www.suoutback.com
