Subaru Outback (BR): Removing air intake duct

Use a screwdriver to undo the clips on the air intake duct, then remove the air
intake duct. Refer to “Type A clips” F11-5.
READ NEXT:
It is necessary to pull off the fender lining when replacing some bulbs.
1. Start the engine and turn the steering wheel fully in the opposite direction
of the bulb to be replaced.
2. Stop the eng
To open the hood:
1. If the wiper blades are lifted off the windshield, return them to their original
positions.
2. Pull the hood release knob under the instrument panel.
3. Release the secon
SEE MORE:
Main fuse box
The main fuses are designed to melt during an overload to prevent damage to the
wiring harness and electrical equipment. Check the main fuses if any electrical
component fails to operate (except the starter motor) and other fuses are good.
A melted main fuse must be replaced.
With the sun visor positioned over the side window, you can use the sun visor
extension plate to prevent glare through the gap between the sun visor and center
pillar. To use the extension plate, pull it toward the rear of the vehicle. When
you have finished using it, stow it by pushing it t
© 2010-2026 Copyright www.suoutback.com
