Subaru Outback manuals

Subaru Outback (BR): Maintenance tips

Some clips and fender linings must be removed before replacing the air cleaner elements or specific bulbs.

READ NEXT:

 Removing and reinstalling clips

Removing clips There are several types of clips used for your vehicle Type A clips 1. Turn the clips counterclockwise using a flat-head screwdriver until the center portion of the clip is raise

 Removing air intake duct

Use a screwdriver to undo the clips on the air intake duct, then remove the air intake duct. Refer to “Type A clips” F11-5.

 Pulling off the fender lining

It is necessary to pull off the fender lining when replacing some bulbs. 1. Start the engine and turn the steering wheel fully in the opposite direction of the bulb to be replaced. 2. Stop the eng

SEE MORE:

 Models with SRS airbags and lap/shoulder restraints for driver, front passenger, and window-side rear passengers

Your vehicle is equipped with a supplemental restraint system in addition to a lap/shoulder belt at each front seating position and each rear window-side seating position. The supplemental restraint system (SRS) consists of six airbags. The configurations are as follows: ● Driver’s and

 General Description of the Seats

A: COMPONENT 1. FRONT SEAT Manual seat LH Backrest heater ASSY Backrest pad Backrest cover Backrest frame ASSY Backrest back cover Headrest bushing Headrest ASSY Flat mat hook S hook Side airbag module ASSY Side airbag tape Se

© 2010-2026 Copyright www.suoutback.com