Subaru Outback (BR): Air inlet selection button (Manual climate Control system)
Subaru Outback (BR) 2010-2015 Owners Manual / Climate control / Manual climate control system (if equipped) / Manual climate Control panel / Air inlet selection button (Manual climate Control system)
ON position (recirculation): Interior air is recirculated inside the vehicle.
Press the air inlet button to the ON position. The indicator light will illuminate. Place this button in the ON position when you wish to cool the cabin quickly or are driving on a dusty road.
OFF position (outside air): Outside air is drawn into the passenger compartment. Press the air inlet button again to the OFF position. The indicator light will turn off. Place this button in the OFF position when you reach a road that is not dusty and when you wish to achieve a comfortable temperature in the cabin.
WARNING
Continued operation in the ON position may fog up the windows. Switch to the OFF position as soon as the outside dusty condition clears.
READ NEXT:
Heater operation
NOTE
● When the “” button or “”
button is pressed the air conditioner compressor automatically operates to quickly
defog the windshield. However the indicator on the air conditioner
Defrosting or defogging the windshield
To direct warm air to the windshield and front door windows:
1. Set the air inlet selection button to the OFF position.
2. Press the “” button.
3. Turn the temperature control dial all the way
Heating and defrosting
To direct warm air toward the floor and the windshield:
1. Set the air inlet selection button to the OFF position.
2. Press the “” button.
3. Set the temperature control dial to the most comfor
SEE MORE:
General Description of Trim
A: COMPONENT
1. FRONT UNDER COVER
Small type
Medium type
Large type
Tightening torque: N*m (kgf-m, ft-lb)
T: 17.5 (1.78, 12.9)
2. FLOOR UNDER PROTECTOR
Tightening torque: N*m (kgf-m, ft-lb)
T: 7.5 (0.76, 5.5)
3. FUEL TANK PROTECTOR
Fuel tank protector RH
F
DTC P0327, P0328, P0335, P0336, P0340, P0341, P0351, P0352, P0353, P0354,
P0400, P0420
BJ:DTC P0327 KNOCK SENSOR 1 CIRCUIT LOW (BANK 1 OR SINGLE SENSOR)
1. OUTLINE OF DIAGNOSIS
Detect the open or short circuit of knock sensor.
Judge as NG if out of specification.
2. COMPONENT DESCRIPTION
To knock sensor harness
Case
Weight
Piezoelectric element
Nut
Resistance
3. ENABLE CON
© 2010-2026 Copyright www.suoutback.com
