Subaru Outback (BR): Charge warning light
Subaru Outback (BR) 2010-2015 Owners Manual / Instruments and controls / Warning and indicator lights / Charge warning light
If this light illuminates when the engine is running, it may indicate that the charging system is not working properly.
If the light illuminates while driving or does not turn off after the engine starts, stop the engine at the first safe opportunity and check the alternator belt. If the belt is loose, broken or if the belt is in good condition but the light remains illuminated, contact your nearest SUBARU dealer immediately.
READ NEXT:
Oil pressure warning light
CAUTION
Do not operate the engine with the oil pressure warning light on. This may cause
serious engine damage.
If this light illuminates when the engine is running, it may indicate that the
e
Engine low oil level warning light
The engine low oil level warning light illuminates when the ignition switch is
turned to the “ON” position and turns off after approximately 2 seconds.
This light also illuminates when the en
AT OIL TEMP warning light (AT and CVT models)
The AT oil temperature warning light “AT OIL TEMP” illuminates when the ignition
switch is turned to the “ON” position and turns off after approximately 2 seconds.
If this light illuminate
SEE MORE:
AUTO button
FULL AUTO mode operation:
When the “AUTO” button is pressed, the indicator light “FULL AUTO” on the display
illuminates. In this state, fan speed, airflow distribution, air-inlet control,
and air conditioner compressor operation are automatically controlled.
AUTO mode operation:
If
Steering Column
A: REMOVAL
1) Adjust the tilt position to the lowest position and lock the tilt lever.
2) Remove the driver's airbag module assembly.
Push in the snap pin using a hexagon wrench or equivalent wrapped with a
protective tape to disengage
the locks (3 locations).
Disconnect the horn harness a
© 2010-2026 Copyright www.suoutback.com
