Subaru Outback (BR): Loading all the magazine (full disc loading mode)
1. If you continue to press the “LOAD” button for more than 1.5 seconds, the player will produce beep sound and will enter the full disc loading mode.
2. When the disc number indicator flashes and “ALL LOAD” indicator illuminates, insert a disc within 15 seconds. If a disc is successfully loaded during this period, the disc number indicator will stop blinking and will steadily light.
3. When the loading of a disc is complete, the next idle disc number indicator will blink. Then repeat step 2.
4. When the magazine is filled with discs by repeating steps 2 and 3, the player will start playback of the discs, beginning with the one inserted first.
If you fail to insert any disc during each 15 seconds interval, the full disc loading mode will be canceled, and the player will start playback of the disc inserted first.
READ NEXT:
How to play back a CD
NOTE
For type A audio, if a disc that the player cannot read has been loaded, the
player will display the message “CHECK DISC”.
When there is no CD inserted
Insert a CD by referring to “How to insert a CD (type A)” F5-19 / “How to insert
a CD (s) (type B)” F5-19.
When a CD is loaded, the player will start playback of the CD, beginning with
th
When CD is in the player (type A)/ When playing back all CDs in the player (type
B)
When the “CD/AUX” button is pressed, the player will start playback.
SEE MORE:
Certification for the Hands-free system
NOTE
● This device complies with Part 15 of the FCC Rules and with RSS-Gen of IC Rules.
Operation is subject to the following two conditions: (1) This device may not cause
harmful interference, and (2) this device must accept any interference received,
including interference that may ca
Passenger's Airbag Module
A: REMOVAL
CAUTION:
Refer to "CAUTION" of "General Description" before handling the airbag module.
<Ref. to AB-9,
CAUTION, General Description.>
1) Turn the ignition switch to OFF.
2) Disconnect the ground cable from battery and wait for at least 60 seconds
before starting work.
3) Remove
