Subaru Outback: Cruise control indicator light

The cruise control indicator light illuminates when the ignition switch is turned
to the “ON” position and turns off after approximately 3 seconds.
This light illuminates when the “CRUISE” main switch is pressed.
NOTE
● If you press the main switch button while turning the ignition switch “ON”,
the cruise control function is deactivated and the “CRUISE” indicator light flashes.
To reactivate the cruise control function, turn the ignition switch back to the
“Acc” or “LOCK” position, and then turn it again to the “ON” position.
● If this indicator light and the CHECK ENGINE warning light/malfunction indicator
lamp flash simultaneously during driving, have the vehicle checked by your nearest
SUBARU dealer.
READ NEXT:
The cruise control set indicator light illuminates when the ignition switch is
turned to the “ON” position and turns off after approximately 3 seconds.
This light illuminates when vehicle spe
This indicator light illuminates under the following conditions.
● when the light switch is turned to the “”
or “” position
● when the light switch is in the “AUTO” posit
This indicator light illuminates while the front fog lights are illuminated.
SEE MORE:
A: INSPECTION
1) Park the vehicle on a level surface.
2) Turn the ignition switch to OFF, and wait until the
engine cools.
3) Remove the collector cover. (turbo model)
4) Remove the oil level gauge and wipe it clean.
5) Reinsert the oil level gauge all the way. Be sure
that the oil level gauge
1) Multi function display switching knob
With the ignition switch in the “ON” position, each successive press of the multi
function display switching knob toggles the display in the following sequence.
© 2010-2021 Copyright www.suoutback.com