Subaru Outback (BR): Cruise control activation indicator light

The indicator light for cruise control activation illuminates upon turning the ignition switch to the “ON” position and remains lit for around 3 seconds.
This light becomes illuminated when the vehicle speed has been successfully set using the cruise control function.
READ NEXT:
The performance and long life of your vehicle are dependent on how you handle
and care for your vehicle while it is new. Follow these instructions during the
first 1,000 miles (1,600 km):
●
The following suggestions will help to save your fuel.
● Select the proper gear position for the speed and road conditions.
● Avoid sudden acceleration or deceleration. Always accelerate
SEE MORE:
If the light is blinking while driving, an engine misfire condition has been
detected which may damage the emission control system.
To prevent serious damage to the emission control system, you should conform
to the following instructions.
● Reduce vehicle speed.
● Avoid hard acce
1) Air intake duct 2) Air cleaner case 3) Clamp
1. Remove the hydraulic hose in the power steering system from the clip on the
air intake duct.
2. Remove the hydraulic hose from the clip on the right side of the air cleaner
case.
3. Unsnap the two clamps holding the air cleaner case cover.
© 2010-2026 Copyright www.suoutback.com
