Subaru Outback: Dome light

1. Remove the lens by prying the edge of the lens with a flat-head screwdriver.

2. Turn the bulb until the flat surfaces at its ends are aligned vertically.
3. Pull the bulb straight downward to remove it.
4. Install a new bulb.
5. Reinstall the lens.
READ NEXT:
1. Remove the lens by prying the edge of the lens with a flat-head screwdriver.
2. Turn the bulb until the flat surfaces at its ends are aligned vertically.
Pull the bulb straight downward to r
1. Remove the lens by prying the edge of the lens with a flat-head screwdriver.
2. Pull the bulb out of the socket.
3. Install a new bulb.
4. Reinstall the lens.
1. Remove the lens by prying the edge of the lens with a flat-head screwdriver.
2. Pull the bulb out of the socket.
3. Install a new bulb.
4. Reinstall the lens.
SEE MORE:
A: REMOVAL
CAUTION:
Immediately after the vehicle has been running or after idling for a
long time, the CVTF will be hot.
Be careful not to burn yourself.
If the CVTF is spilt over exhaust pipe, wipe it off with cloth to
avoid emitting smoke or causing a
fire.
When removing the CVTF cooler
A: PROCEDURE
It is necessary to perform the drive cycle listed below if DTC is not found
in the Inspection Mode. It is possible
to complete diagnosis of the DTC by performing the indicated drive cycle. After
the repair for the DTC, perform
a necessary drive cycle and make sure the function recover
© 2010-2022 Copyright www.suoutback.com
