Subaru Outback (BR): Map light models and functioning
Subaru Outback (BR) 2010-2015 Owners Manual / Interior equipment / Interior light / Map light models and functioning
Models with moonroof
Models without moonroof
To turn on the map light, press the switch.
To turn it off, press the switch again.
When leaving the vehicle, make sure the lights are turned off to avoid battery discharge.
READ NEXT:
Door interlock switch
1) Door interlock switch
Although the map light switches are in the OFF position (manually off), the map
lights can be set to illuminate automatically in conjunction with a door opening,
etc. b
Cargo area light (Outback)
1) DOOR
2) OFF
3) ON
The cargo area light switch has three positions.
DOOR: The light illuminates only when the rear gate is opened.
OFF: The light remains off.
ON: The light remains on contin
Sun visors
To block out glare, swing down the visors. To use the sun visor at a side window,
swing it down and move it sideways.
SEE MORE:
Basic Diagnostic Procedure of LAN System
A: PROCEDURE
CAUTION:
Subaru Select Monitor is required for reading DTC, performing diagnosis, reading current data, customizing and active test (compulsory drive).
Remove foreign matter (dust, water, oil, etc.) from each control module connector during removal and installation.
Basic Diagnostic Procedure of Vehicle Dynamics Control
A: PROCEDURE
CAUTION: Remove foreign matter (dust, water, oil etc.) from the VDCCM&H/U connector during removal and installation.
NOTE:
To check the harness for open or short circuits, shake problem spot or connector.
Refer to "Check List for Interview". <Ref. to VD
© 2010-2026 Copyright www.suoutback.com
