Subaru Outback (BR): Snow tires
WARNING
● When replacing original tires with winter (snow) tires, make sure you use only the same size, construction and load range as the original tires listed on the tire placard. Using other sizes and construction may affect speedometer/ odometer calibration and clearance between the body and tires. It also may be dangerous and lead to loss of vehicle control.
● You must install four winter tires that are of the same size, circumferences, construction, brand, and load range. Mixing other sizes, circumferences or constructions may result in severe mechanical damage to the drive train of your vehicle and may affect ride, handling, braking and speedometer/odometer calibration. It also may be dangerous and lead to loss of vehicle control.
● Do not use a combination of radial, belted bias or bias tires since it may cause dangerous handling characteristics and lead to an accident.
READ NEXT:
Except 2.5 L turbo models
Your vehicle is equipped with “all season tires” which are designed to provide
an adequate measure of traction, handling and braking performance in year-round
driving. In winter, it may be pos
Winter driving on 2.5 L turbo models
Original equipment summer tires are installed on your vehicle, which are not suitable for driving on slippery surfaces like snow-covered or icy roads. Compared to winter and all-season tires, summer t
Tire chains
CAUTION
Tire chains cannot be used on any tires for your Legacy and Outback because of
lack of clearance between the tires and vehicle body.
SEE MORE:
Electronic compass display
By briefly pressing the compass button, the compass display is toggled on or
off. When the compass display is on, an illuminated compass reading will appear
on the mirror.
Using the electronic compass properly, the following compass zone adjustment
and compass calibration will be necessary.
Crankshaft Position Sensor
A: REMOVAL
1) Disconnect the ground cable from battery.
2) Remove the bolt which secures crankshaft position
sensor to oil pump.
3) Remove the crankshaft position sensor, and disconnect
the connector from the crankshaft position
sensor.
B: INSTALLATION
Install in the reverse order of removal.
Tig
