Subaru Outback (BR): Vehicle Dynamics Control (VDC)
READ NEXT:
A: SPECIFICATION
B: COMPONENT
1. ABS WHEEL SPEED SENSOR
Front ABS wheel speed sensor
Front axle housing
Rear ABS wheel speed sensor
Rear axle housing
Hub unit bearing
A: REMOVAL
1) Disconnect the ground cable from battery.
2) Remove the air intake boot.
H4 model: <Ref. to IN(H4DOTC)-10, REMOVAL, Air Intake Boot.>
H6 model: <Ref. to IN(H6DO)-7, REMOVAL,
A: OPERATION
1) While the ABS sequence control is being performed, the operation of the
hydraulic unit can be checked using
the brake tester or pressure gauge after the hydraulic unit solenoid valve
SEE MORE:
1) Raise
2) Lower
The raising function will only operate when the moonroof is fully closed. The
lowering function will only operate when the moonroof is raised.
Press the rear side of the “UP/DOWN” switch to raise the moonroof. Press the
front side of the “UP/DOWN” switch to lower t
A: REMOVAL
1) Disconnect the ground cable from battery.
2) Using the refrigerant recovery system, discharge refrigerant. <Ref. to AC-24,
PROCEDURE, Refrigerant
Recovery Procedure.>
3) Drain the coolant from the radiator.
H4 non-turbo model: <Ref. to CO(H4SO)-14, DRAINING OF ENGINE COOL
© 2010-2026 Copyright www.suoutback.com
