Subaru Outback (BR): VDC warning light / VDC operation indicator light
Subaru Outback (BR) 2010-2015 Owners Manual / Instruments and controls / Warning and indicator lights / VDC warning light / VDC operation indicator light
The light illuminates when the ignition switch is turned to the “ON” position and turns off several seconds after the engine has started. This lighting pattern indicates that the Vehicle Dynamics Control system is operating normally.
READ NEXT:
Vehicle Dynamics Control warning light
CAUTION
The Vehicle Dynamics Control system provides its ABS control through the electrical
circuit of the ABS system. Accordingly, if the ABS is inoperative, the Vehicle Dynamics
Control system
Vehicle Dynamics Control operation indicator light
The indicator light flashes during activation of the skid suppression function
and during activation of the traction control function.
NOTE
● The light may remain illuminated for a short per
Vehicle Dynamics Control OFF indicator light
The light illuminates when the ignition switch is turned to the “ON” position
and turns off after approximately 2 seconds. The light illuminates when the Vehicle
Dynamics Control OFF switch
SEE MORE:
Heater Duct
A: REMOVAL
1) Remove the front seats. <Ref. to SE-10, REMOVAL, Front Seat.>
2) Remove the instrument panel face assembly. <Ref. to EI-76, REMOVAL,
Instrument Panel Assembly.>
3) Remove the rear heater duct.
Pull off the floor carpet to disengage the rear heater duct slide lock.
Rel
Occupant Detection System (Diagnostics)
Basic Diagnostic Procedure
A: PROCEDURE
Check List for Interview
A: CHECK
General Description
A: CAUTION
1) If the seat cushion cover is removed or replaced,
make sure to perform the occupant detection system
adjustment after installing the seat to the vehicle.
<Ref. to OD(diag)-15, System Cal
© 2010-2026 Copyright www.suoutback.com
